Section 1
7
SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS
1.1 SAFETY REGULATIONS:
1. When operating the air dryer, the operator
must adopt safe working methods and
observe all local safety instructions and rele-
vant regulations.
2. Prior to installation, the dryer and the com-
pressed air system are to be depressurized
and disconnected from the electrical main
supply.
3. The user is responsible for safe operating
conditions. Parts and accessories must be
replaced if inspection shows that it is unsafe
to operate the dryer.
4. Installation, operation, maintenance and
repair are only to be performed by autho-
rized, trained and skilled technicians.
5. The minimum and maximum values listed on
the data label must be strictly followed. If
your application does not fall within the
parameters indicated on the data label—
STOP. Contact your Sullair representative/
distributor and clarify the issue before pro-
ceeding or operating the dryer.
6. All safety procedures and practices men-
tioned in this manual must be observed, as
well as all of the federal, state and local
safety precautions.
7. If any statement in this manual does not
comply with the local legislation, the stron-
gest standard is to be applied.
1.2 ISSUES TO AVOID
1. Any structural changes made to the dryer
without the advise of Sullair or Sullair repre-
sentatives will void all warranty.
2. Compressed air from this dryer does not
meet the OSHA standards for breathing and
hence it should not be used for breathing
purposes.
None of the protective alarms, equipment or
devices should be tampered with. These pro-
tective items have been designed and
installed on this dryer for your safety.
3. Do not operate the dryer at pressures, tem-
peratures of flow other than the ones men-
tioned on the data label.
1.3 RECEIVING AND
INSPECTION
Sullair dryers are factory tested prior to shipment.
However, during shipment, there are chances that
the dryer was mishandled or certain parts were
broken or might have come loose. In order to ensure
that the dryer you have received is fit for installation
and operation, we recommend you take a few
minutes to inspect the dryer for any physical abuse
or damage during shipment.
If you notice any damage to the shipment, we
recommend you take the following steps to ensure
proper arrangements can be made to address the
issue.
1. Immediately file a complaint with the ship-
ping company.
2. Contact Sullair or Sullair distributor and
inform them of the damage. (Email or fax the
copy of the shipper claim and acknowledge-
ment)
If there is no physical damage to the dryer—
1. Remove all the crating and packaging.
2. Inspect the dryer for electrical and piping
connection and make sure that they are all
tight.
3. Check the data label, your packing slip and
make sure that it is the correct unit you had
ordered.
4. Follow the recommended safety procedures
and get the dryer ready for installation.
To Next Page
Loading...
Need help?
General
