INSTALLATION, START-UP & MAINTENANCE MANUAL
MODEL NO.: SD-820 / SD-1710
REV 1 – AUGUST 03,.2001
Page 7
SECTION 1
Attention!
−
Never make structural changes to the adsorption
dryer!
−
Only use original spare and accessory parts!
−
Never weld on a pressure vessel or change it in any
way!
Carry out maintenance work only when the adsorption
dryer is switched off, is depressurized and
disconnected from the electric power supply.
* Advices
Refer to the desiccant material safety data sheet (MSDS) when installing or
disposing of desiccant.
Danger!
Wear protective goggles when working with the
desiccant!
* Advices for protection
−
If desiccant comes into contact with the eyes, rinse eyes immediately with a lot of
clear water.
−
If the desiccant is spilled, clean up without causing swirls of dust.
−
In case of fire, there is no restriction on the use of fire extinguishing material; the
reaction with water and foam is defined as strong.
−
A mask must be worn.
1.3 PERSONNEL QUALIFICATION
The personnel involved in operation, maintenance, inspection and assembly must have
the corresponding qualifications to do this work. Areas of responsibility and supervision
of the personnel must be precisely established by the operator. Should the personnel
not possess the necessary knowledge, then they must be trained and instructed. If need
be, this training may be carried out by the manufacturer / supplier at the request of the
operator of the adsorption dryer. Further, the operator is to make sure that the
personnel completely understand the contents of the technical manual.
To Next Page
Loading...
Need help?
General
