Sullair Supervisor - Page 34

Section 6
SUPERVISOR PROTOCOL
28
Parameter Supervisor Supervisor Description Digits Units
II Controller
9 * * Wye-Delta time nn sec
10 * * Drain Interval Time nn min
11 * * Drain Time nn sec
12 * * Restart time nn sec
17 * Stop Timer nn sec
18 * Sequence com number nn
19 * * eConnect ID nn
20 * * Seq number of machines nn
21 * * Sequence method n list (IV)
22 * * Sequence hours nnnnnn hour
23 * * Sequence lowest pressure nnn psi
24 * * Sequence recover time nn sec
25 * * Machine max capacity nnnnn cfm
26 * * Seq Rotate time nnn hour
30 * Modulate n y/n
31 * Pressure units n list (V)
32 * VSD setpoint nnn psi
40 * T1 calibrate n
41 * T2 calibrate n
42 * T3 calibrate n
43 * T4 calibrate n
44 * T5 calibrate n
45 * T6 calibrate n
45 * Pressure calibrate password nnn
46 * * P1 calibrate n
47 * * P2 calibrate n
48 * * P3 calibrate n
49 * * P4 calibrate n
50 * * dP1 calibrate n
51 * P3 maximum n
54 * Maintenance warning nnnn hour
55 * Maintenance filter nnnnn hour
(IV) 0= Disabled / 1= Remote
(V) 0= psi / 1= bar / 2= kPa
Continued on page 29