Need help?Do you have a question about the Summa SummaCut D60 and is the answer not in the manual?
Provides information for servicing the SummaCut D60 and D120 cutters.
Outlines the sections included in the service manual.
Explains correct placement of the cutter on a surface to avoid damage.
Identifies and describes the main components of the cutter.
Details the location and function of rear panel controls and ports.
Details the location and function of front panel controls and display.
Describes the control panel and its main functions, including LCD and keys.
Explains the 16-character LCD's role in displaying status and menu options.
Details the function of the Menu key for accessing cutter settings and submenus.
Explains how the X key cancels operations or stops cutting.
Describes the V key's role in confirming menu selections and saving changes.
Explains how the Test key activates specific test routines within submenus.
Details the use of jogging keys for submenu navigation and value adjustment.
Explains various common menu items for cutter configuration and operation.
Sets or modifies the tool's cutting velocity, with default and range specified.
Sets or modifies the cutting pressure for the pen tool.
Sets or modifies the cutting pressure for the knife tool.
Sets or modifies the distance between the knife blade tip and the centre axis.
Sets or modifies the pouncing pressure for the pouncing tool.
Sets or modifies the distance between pounced wholes for the pouncer.
Performs a complete reset of the cutter's functions.
Re-executes the last file sent to the cutter.
Initiates a media loading sequence, including origin and length adjustment.
Submenu for contour cutting alignment, refers to user manual for details.
Covers menu items for initial cutter setup and configuration.
General| Model | SummaCut D60 |
|---|---|
| Category | Printer |
| Max. Axial Acceleration | 3 G |
| Knife Pressure | 0-400 grams |
| Connectivity | USB, Serial |
| Interfaces | USB, Serial |
| Blade Type | Drag knife |
| Interface | USB, Serial |
| Power Requirements | 100-240 V AC, 50/60 Hz |
| Max Cutting Speed | 1131 mm/s |
| Operating System Compatibility | Windows |
| Media Thickness | 0.05 mm to 0.25 mm |
| Cutting Speed | 1131 mm/s |
| Software Compatibility | WinPlot, MacSign |
To Next Page
