Need help?Do you have a question about the Summa S2 CLASS and is the answer not in the manual?
Provides general information about the Summa Service Manual for S Class cutters.
Details the structure and sections within the service manual.
General information and safety precautions for part replacement procedures.
Procedure for removing the left-hand cover of the cutter.
Procedure for removing the right-hand cover of the cutter.
Procedure for removing the bottom plate of the cutter.
Step-by-step instructions for replacing pinch rollers.
Procedure for replacing the media sensors.
Instructions for replacing the cutting/pouncing strip.
Procedure for replacing the X-motor.
Procedure for replacing the Y-motor.
Procedure for replacing the touch screen assembly.
Procedure for replacing the main printed circuit board (PCB).
Steps to replace the power supply unit.
Procedure for replacing the cutter's toolhead.
Procedure for replacing the flatcable assembly.
Procedure for replacing the drive drum assembly.
How to set or reset the machine type.
Procedure for recalibrating length calibration.
Procedures for calibrating the cutter head.
Procedure for calibrating the media sensors.
Procedure for calibrating the OPOS system.
Procedure for calibrating the right margin.
Procedure for calibrating the touch screen.
Overview of the touch screen interface and its functions.
Accessing and navigating the cutter's configuration menu.
Importance of maintenance and cleaning for cutter performance.
Instructions for cleaning the drive system components.
Procedure for cleaning the media sensors.
Instructions for cleaning the sliding surfaces of the Y guiding.
Procedure for cleaning the nose piece of tangential cutters.
Procedure for cleaning the OPOS system's optical components.
Step-by-step guide for safely changing the fuse.
Troubleshooting steps for X-axis overflow or overcurrent errors.
Troubleshooting steps for Y-axis overflow or overcurrent errors.
Steps to resolve issues with the cutter not finding the knife home position.
Troubleshooting steps when the up/down encoder is not functioning.
Steps to resolve issues with the OPOS not lowering correctly.
Troubleshooting common OPOS sensing errors and their causes.
Resolution for illegal plot commands in DMPL format.
Troubleshooting HPGL syntax errors encountered by the machine.
Handling NVRAM failures and associated messages.
Troubleshooting internal firmware or main board errors.
Resolving errors encountered during firmware upgrades.
Steps to take when a RAM error occurs.
Information on power and USB cables for cutter connectivity.
Accessories including flanges and rollers for media management.
Various knife holders, blades, and related parts for cutter operation.
Pens, pen holders, and pouncing tools for plotting functions.
Replacement cutting and pouncing strips for maintaining cutter performance.
List of parts included in the S2 Class 'First Aid Kit'.
List of parts included in the S2 T Class 'First Aid Kit'.
To Next Page
General
