Summa S2 CLASS - Table of Contents

TOC 1
Table of Contents
Service manual ................................................................................................. 1-1
1 Setup ........................................................................................................... 1-1
INTRODUCTION ........................................................................................ 1-1
1.1 Overview .......................................................................................... 1-1
1.2 Manual organization ........................................................................ 1-1
1.3 Quick tour around the machine ..................................................... 1-3
1.3.1 The Cutter as viewed from the Front ................................................... 1-3
1.3.2 The Cutter as viewed from the Back ................................................... 1-4
2 Replacements guidelines......................................................................... 2-1
2.1 General ............................................................................................. 2-1
2.2 Precautions ...................................................................................... 2-1
2.3 Removing the left-hand cover ........................................................ 2-3
2.4 Removing the right-hand cover ..................................................... 2-3
2.5 Removing the bottom plate ............................................................ 2-5
2.6 Replacing the pinch rollers ............................................................ 2-5
2.7 Replacing the media sensors ......................................................... 2-7
2.8 Replacing the cutting/pouncing strip ............................................ 2-7
2.9 Replacing an X-motor ..................................................................... 2-9
2.9.1 Replacing the X-motor with the encoder .............................................. 2-9
2.9.2 Replacing the X-motor without the encoder ......................................... 2-9
2.10 Replacing the Y-motor .................................................................. 2-11
2.11 Replacing the touch screen ......................................................... 2-13
2.12 Replacing the pinch roller switch ................................................ 2-14
2.13 Replacing the main PCB ............................................................... 2-15
2.13.1 Required Tools .................................................................................. 2-15
2.13.2 Procedure ......................................................................................... 2-15
2.14 Replacing the Power Supply ........................................................ 2-21