Service Manual SummaCut D60-D120
7. Pinch rollers: - The pinch rollers (one at each side) hold the media clamped
between the rubber rollers and the media drive sleeves. (The D120 has an extra
guidin pinch roller in the middle)
8. Cutting strip: - Soft strip to avoid any damage to the knife tip when no media has
been loaded. Since cutting is done on the cutting strip it is essential that the
cutting strip remains intact.
9. Alignment strip: - Front alignment strip for easier media loading.
10. Media guide : - Extra guide to prevent badly curled up media from jamming
under the cutter (not in 120 Model)
Introduction I-7
To Next Page
Loading...
