SummaCut D60-D120 Service Manual
This part contains an overview of the various tests and configurations that can be
accessed via the keyboard.
General replacement guidelines contains the following:
An overview of the removal and the replacement of various parts of the unit in the form
of separate chapters. It is advisable to carefully read the procedure described in each
of the chapters prior to removing or replacing a particular part. In addition to
straightforward step by step procedures you will often find Notes and Cautions. Make
sure you read these remarks as they will often facilitate re-installation and avoid
malfunctioning.
Maintenance contains the following:
An overview of the maintenance of various parts of the unit. It is advisable to carefully
read the procedure described in each of the chapters prior to removing or replacing a
particular part. You will often find Notes and Cautions. Make sure you read these
remarks as they will often avoid malfunctioning.
Calibration:
An overview of all the possible calibrations of the unit. Each time the machine is
serviced check this section to see if any recalibration needs to be done.
Troubleshooting:
An overview of all the possible error messages that could appear on the LCD screen,
and the possible solutions
Spare parts list
An overview of all the recommended spare parts. Normally only the parts figuring on
this list will be provided by Summa.
I-2 Introduction
To Next Page
Loading...
