Need help?Do you have a question about the Summa SummaSign D1300 PRO and is the answer not in the manual?
Explains the functions of the liquid crystal display (LCD) and control panel keys.
Covers on line, off line, and local operation modes of the cutter.
Procedure to recalibrate the machine for accurate media handling.
Covers knife and coil calibration procedures for optimal performance.
Steps for calibrating the optical positioning system for precise cuts.
Cause and action for the "MOTOR HOT" error message.
Troubleshooting steps for fatal errors related to X-axis movement.
Troubleshooting steps for fatal errors related to Y-axis positioning.
Identifies and resolves issues related to low input voltage.
Identifies and resolves issues related to high input voltage.
Troubleshooting for non-fatal and fatal NVRAM issues.
Explains and resolves internal firmware or main board errors.
Troubleshooting errors during firmware flashing on newer PCBs.
Addresses issues related to failing Read-Only Memory (ROM).
Addresses issues related to failing Random Access Memory (RAM).
Troubleshooting when the machine cannot locate the knife's home position.
Troubleshooting when the machine fails to sense markers correctly.
List of spare parts for the SummaCut D500 model.
List of spare parts for the SummaSign D610 model.
List of spare parts for the SummaSign D610 Pro model.
List of spare parts for the SummaSign T610 model.
List of spare parts for the SummaSign T610 Pro model.
List of spare parts for the SummaSign D750 model.
List of spare parts for the SummaSign D750 Pro model.
List of spare parts for the SummaSign T750 model.
General| Max Cutting Force | 400 grams |
|---|---|
| Connectivity | USB, Ethernet |
| Max Cutting Speed | 113 cm/s |
| Maximum Media Width | 1370 mm |
| Repeatability | 0.1 mm |
| Power Supply | 100-240V AC, 50/60Hz |
To Next Page