Need help?Do you have a question about the Summa SummaSign T1010 PLUS and is the answer not in the manual?
Explains the control panel functions, LCD, and keys.
Accesses various internal tests and routines.
Detailed steps for replacing the main printed circuit board.
Steps to replace the drag or tangential cutting head.
Steps to replace the media sensors.
Steps to replace the drive drum.
Cleans accumulated residue from drive drum sleeves.
Details voltage conversion and fuse replacement.
Resets machine type after PCB change or special init.
Recalibrates the unit when drum, camrollers, or PCB are replaced.
Calibrates the OPOS (Optical positioning system).
Addresses overheating of motors, especially the X-motor.
Addresses errors when secondary transformer voltage is too low.
Solves fatal errors when the drum motor cannot move.
Addresses errors when secondary transformer voltage is too high.
Solves fatal errors when the head cannot move to position.
Addresses non-fatal and fatal NVRAM errors.
Machine cannot find the home position for the tangential knife.
Machine has trouble during special load sequence with markers.
General| Connectivity | USB, Ethernet |
|---|---|
| Weight | 24 kg (53 lbs) |
| Interfaces | USB, Ethernet |
| Resolution | 0.025 mm |
| Interface | USB, Ethernet |
| Cutting Width | 1000 mm |
| Power Supply | 100-240 VAC, 50-60 Hz |
To Next Page