Need help?Do you have a question about the Summa SummaSign T1010 PRO and is the answer not in the manual?
Covers concatenation, smoothing, emulate, tool, units, addressing, baud rate, parity.
Detects and corrects concentricity issues with the tangential knife blade.
Procedures for adjusting origin, lateral, and longitudinal knife alignment.
Tests for cut border, menu plot, confidence, and DIN quality checks.
Covers calibration, tracking, friction plot, and RS232 serial communication tests.
Lists common sense rules and procedures to follow while servicing the unit.
Details the steps to remove the left-hand cover of the cutter.
Details the steps to remove the right-hand cover of the cutter.
Provides instructions for removing and replacing the cam rollers.
Steps to replace X-motors with or without an encoder.
Steps for removing PCB components, grouping top and rear locations.
Detailed steps for removing the drag head assembly.
Steps for replacing the flat cable connected to the cutter head.
Instructions for replacing the cutting strip on the cutter.
Details the procedure for replacing the fan motor.
Procedure to clean drive sleeves using a vinyl strip to remove residue.
Steps for cleaning the nose piece to prevent poor cut quality.
Steps for recalibrating coil settings for pressure adjustment.
Provides info on error codes and step-by-step procedures to prevent them.
Covers MOTOR HOT, ERROR IN X-AXIS, ERROR IN Y-AXIS POSITION.
Covers LOW/HIGH LINE VOLTAGE, ILLEGAL PLOT COMMAND, ILLEGAL CLIP & SCALE.
Covers SYNTAX ERROR, NVRAM, RS232, INTERNAL ERRORS.
Covers FLASHING ERRORS, ROM ERROR, RAM ERROR.
Covers KNIFE HOME POSITION and MARKERS NOT SENSED PROPERLY.
Steps to flash flash ROMs from internal ROMs when unable to boot PCB.
How to check and recalibrate the pinch roll lever play for tracking.
Method to change the motor on a T-head, ensuring belt tension.
To Next Page
General