Need help?Do you have a question about the Summa SummaSign D1300 and is the answer not in the manual?
Guide to configuring cutter parameters via user menus.
Covers tangential knife calibration and related adjustment routines.
Essential safety and handling rules for unit servicing.
Guides for removing covers, bottom plate, and internal components.
Step-by-step instructions for removing left and right covers.
Procedures for removing the bottom plate and replacing cam rollers.
Instructions for replacing X-motors, Y-motor, and drive drum.
Procedures for replacing cutting heads, flat cables, and Y-belts.
Addresses motor hot errors and X/Y axis position errors.
Covers low/high voltage, illegal commands, syntax, NVRAM, and RS232 errors.
Troubleshooting for problems with marker sensing.
General| Connectivity | USB, Ethernet |
|---|---|
| Power Requirements | 100-240 V AC, 50/60 Hz |
| Cutting Speed | 113 cm/s |
| Blade Type | Tangential |
| Contour Cut Accuracy | +/- 0.1 mm |
| Media Advance Accuracy | +/- 0.1 mm |
| Repeatability | +/- 0.1 mm |
| Maximum Media Width | 135 cm (53") |
To Next Page