Need help?Do you have a question about the Summa SummaSign T610 PRO and is the answer not in the manual?
Explains the functions of the LCD and control panel keys.
Provides access to submenus for configuring operating parameters.
Configures initial setup parameters for cutter and software compatibility.
Provides access to various internal diagnostic tests.
Routine to detect and correct tangential knife blade concentricity.
Procedure to adjust the knife origin position.
Procedure to correct vertical knife misalignment.
Procedure to correct horizontal knife misalignment.
Details tests for language, ROM, sensors, and communication.
Adjusts the length of cut lines to specifications.
Calibrates knife and pen pressure and sets the tool landing.
Common sense rules and procedures for servicing the unit.
Step-by-step instructions for replacing the main printed circuit board.
Procedure for replacing the drag or tangential cutting head.
Guide for changing the cutter's AC voltage setting and fuses.
Procedure for resetting the machine type after PCB changes.
Calibrating the unit when media thickness affects accuracy.
Calibration routines for the cutting head assembly.
Routine to detect and correct tangential knife blade concentricity.
Calibrating the coil pressure for the cutting head.
Calibrating the Optical Positioning System.
Standard procedure for calibrating the OPOS system.
Fine-tuning the OPOS system for specific media or conditions.
Troubleshooting for motor overheating errors.
Troubleshooting for errors related to X-axis movement.
Troubleshooting for errors related to Y-axis movement.
Troubleshooting for errors indicating low input voltage.
Troubleshooting for errors indicating high input voltage.
Troubleshooting errors from invalid plot commands (DM/PL).
Troubleshooting errors from incorrect clip/scale parameters (DM/PL).
Troubleshooting errors related to incorrect HPGL command syntax.
Troubleshooting errors related to NVRAM data integrity.
Troubleshooting errors during RS232 serial communication.
Troubleshooting firmware or main board internal errors.
Troubleshooting errors during firmware flashing.
Troubleshooting errors indicating faulty ROMs.
Troubleshooting errors indicating faulty RAM.
Troubleshooting errors when the machine cannot find the knife home position.
Troubleshooting errors when markers are not detected correctly.
General| Cutting Technology | Drag knife |
|---|---|
| Power Supply | 100-240 VAC, 50/60 Hz |
| Cutting Width | 610 mm (24 inches) |
| Interface | USB, Ethernet |
| Repeatability | 0.1 mm |
| Media Types | Vinyl |
| Operating Systems | Windows, macOS |
To Next Page