Need help?Do you have a question about the Summa SummaSign T1300 and is the answer not in the manual?
Details the functions of the LCD and control panel keys on the SummaSign cutters.
Explains on line, off line, and local operation types for cutting and plotting.
Information on replacing defective parts and adjustment procedures with step-by-step guides.
Detailed steps for replacing key components like motors, PCB, heads, and belts.
Procedures for tangential knife calibration and coil calibration.
Information on error codes appearing on the LCD and step-by-step prevention.
Troubleshooting for 'MOTOR HOT', 'ERROR IN X-AXIS', and 'ERROR IN Y-AXIS POSITION'.
Troubleshooting for 'LOW LINE VOLTAGE', 'HIGH LINE VOLTAGE', and command errors.
Troubleshooting for communication issues like 'RS232 ERROR' and 'SYNTAX ERROR'.
Troubleshooting for NVRAM, internal, ROM, RAM, and operational errors.
Configuring Knife, Pen, and Pouncing Pressure, and Knife Offset.
Detailed steps for Tangential Knife, Origin, Lateral, and Longitudinal calibration.
To Next Page
General