Need help?Do you have a question about the Summa SummaSign D500 and is the answer not in the manual?
Explains the control panel, LCD display, and key functions for operation and configuration.
Details the operation of specific keys like RESET/LOAD, ON LINE, MENU, ENTER, and navigation keys.
Covers on line, off line, and local operation types for cutting or plotting.
Guides users through setting parameters like pressure, velocity, offsets, and communication protocols.
Details internal tests, various calibration routines, and system checks for machine setup.
Details procedures for calibrating the cutting head, tangential knife, and coil settings.
Explains the optional OPOS system calibration and fine-tuning process for optical positioning.
Details troubleshooting steps for motor overheating and axis positioning errors.
Addresses issues related to power supply voltage and incorrect command syntax or parameters.
General| Contour Cutting | Yes |
|---|---|
| Connectivity | USB |
| Software Compatibility | Adobe Illustrator, CorelDRAW |
| Repeatability | 0.1 mm |
| Power Supply | 100-240 V, 50/60 Hz |
To Next Page