Need help?Do you have a question about the Summa SummaSign D610 and is the answer not in the manual?
Overview of the cutter's control panel, LCD, and keys.
Detailed steps for replacing X and Y motors in various models.
Instructions for replacing the main and small PCBs.
Procedures for replacing drag/tangential heads and flat cables.
Setting the machine type via keyboard or computer after PCB replacement.
Recalibrating for media thickness variations for accurate cuts.
Covers knife and coil calibration to ensure optimal cutting quality.
Calibrating the OPOS system and fine-tuning for optimal performance.
Troubleshooting "MOTOR HOT", "ERROR IN X-AXIS", and "ERROR IN Y-AXIS POSITION".
Addresses "LOW LINE VOLTAGE", "HIGH LINE VOLTAGE", and RS232 errors.
Resolving "ILLEGAL PLOT COMMAND", "ILLEGAL CLIP & SCALE SETTINGS", and "SYNTAX ERROR".
Deals with NVRAM failures, internal errors, ROM/RAM errors, and flashing issues.
Troubleshooting issues like unable to find home position or markers not sensed.
Step-by-step guide for reflashing internal ROMs if the unit cannot boot.
General| Contour Cutting | Yes |
|---|---|
| Max Cutting Speed | 600 mm/s |
| Max Media Thickness | 0.5 mm |
| Weight | 44 lb |
| Cutting Force | 400 g |
| Maximum Media Width | 610 mm |
| Cutting Speed | 600 mm/s |
| Repeatability | 0.004 in (0.1 mm) |
| Media Thickness | 0.5 mm |
| Power Supply | 100-240 V, 50/60 Hz |
To Next Page