Need help?Do you have a question about the Summa SummaSign D610 PRO and is the answer not in the manual?
Explains the control panel of SummaSign series cutters, including keys and display.
Describes the function and operation of the RESET/LOAD key for various commands.
Explains how the ON LINE key toggles between operational modes and suspends operations.
Describes the function of the MENU key for accessing cutter menus and configurations.
Explains the use of the ENTER key for selecting menu items and confirming actions.
Details the use of jogging keys for navigation and parameter adjustment within menus.
Covers on line, off line, and local operation modes for cutting and plotting.
Details how to select and alter cutter configuration parameters stored in memory.
Procedure to access and perform various internal tests for diagnostics and calibration.
Explains system tests for occasional adjustments and checks of the cutting process.
Common sense rules and procedures for servicing the unit safely and effectively.
Step-by-step instructions for removing the left-hand cover of the machine.
Step-by-step instructions for removing the right-hand cover of the machine.
Step-by-step instructions for removing the bottom plate of the machine.
Procedure for replacing the cam rollers, including notes on pairs and models.
Instructions for replacing the X-motor in specific older models of the cutter.
Instructions for replacing X-motors in newer models of the cutter.
Instructions for replacing the Y-motor, including connector and belt tensioning.
Procedures for replacing the LCD screen and the keyboard unit.
Instructions for replacing the main printed circuit board (PCB).
Instructions for replacing the small PCB located on the main PCB.
Procedure for replacing the drag or tangential cutting head.
Instructions for replacing the flat cable connecting the cutting head to the PCB.
Procedure for replacing the Y-belt, including tensioning guidance.
Instructions for replacing the cutting strip on the machine.
General| Cutting Width | 610 mm |
|---|---|
| Cutting Technology | Drag knife |
| Contour Cutting | Yes |
| Repeatability | 0.1 mm (0.004 in.) |
| Resolution | 0.025 mm |
| Interface | USB |
| Software Compatibility | Summa Cutter Control |
| Power Requirements | 100-240 V, 50/60 Hz |
To Next Page