Need help?Do you have a question about the Summa SummaSign T1300 PRO and is the answer not in the manual?
Describes the function of the RESET/LOAD key for origin setting, loading, resetting, aborting, and recutting.
Covers settings like Knife Pressure, Knife Offset, Velocity, and Overcut for cutter configuration.
Provides access to various internal tests for machine diagnostics and calibration.
Explains the procedure to detect and correct concentricity issues with the tangential knife.
Verifies the cutter's RS-232-C serial communications circuits and handshaking.
Detailed procedure for replacing the X-motor in specific SummaSign models.
Procedure to reset the machine type after PCB replacement or configuration issues.
Steps to recalibrate the unit when a drum, camrollers, or PCB has been replaced.
Instructions for recalibrating the tangential knife for optimal cutting quality.
Explains the procedure to calibrate the OPOS optical positioning system.
Explains the "MOTOR HOT" message and actions to take for motor overheating.
General| Max Cutting Length | unlimited |
|---|---|
| Cutting Technology | Drag knife |
| Connectivity | USB, Ethernet |
| Power Requirements | 100-240 V, 50/60 Hz |
| Operating Temperature | 15-30°C |
| Repeatability | 0.1 mm |
| Resolution | 0.025 mm |
To Next Page