Need help?Do you have a question about the Summa SummaSign D1010 and is the answer not in the manual?
Describes essential keys like RESET/LOAD, ON LINE, MENU, ENTER, and JOGGING.
Guides through calibration for Tangential knife, origin, lateral, and longitudinal alignment.
Step-by-step instructions for replacing covers, motors, PCB, heads, cables, belts, sensors, and drums.
Procedures for recalibrating media and head alignment for optimal cutting.
Calibrates the optical positioning system and provides fine-tuning steps.
Lists and explains common error messages and their solutions for motors, axes, voltage, and software.
To Next Page
General