Service Manual SummaSign
REPLACING THE FLAT CABLE FOR THE HEAD
Below is the description for the replacement of the flat cable in small cutters. Large cutters - the
models D/T 1300, D/T 1010 (plus) - have an extra strip that is located along the flat cable. The
purpose of this additional strip is to prevent the flat cable from crumpling. For more information, see
Additional strip in larger units at the end of this chapter.
To replace the flat cable for the head, proceed as follows:
85.Remove the left-hand cover (see Chapter 1, Removing the left-hand cover).
86.Remove the right-hand cover (see Chapter 2, Removing the right-hand cover).
87.Remove the two screws on either side of the top cover.
88.Remove the top cover.
89.Loosen one end of the flat cable (the one attached to the PCB) by pulling the flat cable connector
cover up. On both sides of the connector cover there is a small protuberance that you can pry up
using a screwdriver. Gently pull the flat cable out of the connector.
90.Pull the flat cable for the head off the flat cable for the keyboard.
91.
63. Note:
64. Pay close attention to the way the flat cable has been folded. It is advisable to
fold the flat cable in exactly the same way when re-installed.
92.
93.Loosen the flat cable which has been glued to the inner side of the shaft's upright edge.
94.Remove the two screws (three screws in the case of a T-head) of the top cover of the head holding
the flat cable in place.
95.Remove the cover.
96.
65. Note:
66. Pay close attention to the way the flat cable has been folded. The flat cable
will need to be folded in exactly the same way when re-installed.
67. Loosen the end of the flat cable attached to the head. Follow the same
procedure as before (see point 5).
Replacement Guidelines 2-25
To Next Page
Loading...
