SummaSign series Cutters Service Manual
DM/PL ERRORS
The DM/PL ERRORS submenu is used to determine whether or not different DM/PL
errors, such as illegal plot commands, invalid parameter ranges or communication
errors, will be displayed on the LCD. This menu will only be displayed if
PLOT LANGUAGE is set to DM/PL.
The DM/PL ERRORS submenu can be set to REPORTED or IGNORED.
On the LCD, the active setting is marked with an *.
The feature is activated by selecting REPORTED. It is normally used only when
attempting to debug a communication link between the cutter and the host computer.
After the communication link has been debugged, select IGNORED to disable the
feature.
HP/GL ERRORS
The HP/GL ERRORS submenu is used to determine whether or not different HP/GL
errors, such as illegal plot commands, invalid parameter ranges or communication
errors, will be displayed on the LCD. This menu will only be displayed if
PLOT LANGUAGE is set to HP/GL.
The HP/GL ERRORS submenu can be set to REPORTED or IGNORED.
On the LCD, the active setting is marked with an *.
The feature is activated by selecting REPORTED. It is normally used only when
attempting to debug a communication link between the cutter and the host computer.
After the communication link has been debugged, select IGNORED to disable the
feature.
HP/GL ORIGIN
The HP/GL ORIGIN submenu will only be displayed if the PLOT LANGUAGE is set to
HP/GL. (See Paragraph 1.4.4.) The HP/GL ORIGIN submenu is used to set the origin
in the centre (see HP/GL 758x) or the bottom-right corner (see HP/GL 7475) of the
loaded media.
The HP/GL ORIGIN option can be set to RIGHT_FRONT or CENTRE.
On the LCD, the active setting is marked with an *.
If the cut is found to be incomplete, and is wholly located in the upper left corner of the
media then modify the HP/GL ORIGIN setting to RIGHT FRONT. If the cut is found to
be incomplete, and is wholly located in the lower right corner of the media then change
the HP/GL ORIGIN setting to CENTRE.
1-16 Keyboardcontrols
To Next Page
Loading...
