Service Manual SummaSign series Cutters
SYSTEM SET UP
CONCATENATION
The CONCATENATION feature increases the speed and quality with which cut data
having a very high resolution is cut. However when changing over to normal characters
again, deactivate concatenation by setting this parameter to 0.
On the LCD, the active concatenation value is marked with an *.
SMOOTHING
The SMOOTHING feature helps to cut smoother curves when curve data with many
short vectors is received from the computer.
The default setting is OFF.
On the LCD, the active setting is marked with an *.
EMULATE
The EMULATE submenu is used to select the active cutting/plotting language for the
cutter.
The SummaSign Pro cutters support DM/PL , HP/GL and HP/GL/2.
On the LCD, the active plotting language setting is marked with an *.
NOTE
The active cutting/plotting language MUST match the cutting software.
Always select a language which is supported by the host computer's cutting
software.
Whenever possible, select the DM/PL menu option to set the active cutting/plotting
language to Houston Instrument Digital Microprocessor/Plotting Language (DM/PL).
This selection will allow the cutter to operate with DM/PL-based cutting / plotting
software. This language, having special command extensions for cutting, normally
gives superior cutting performance.
Select the HP/GL menu option to set the active cutting/plotting language to HP/GL. The
cutter will emulate an HP model 758xB plotter (with selectable origin, see 1.4.12).
TOOL
The TOOL submenu is used to select the default tool at power up.
To configure the cutter for TANGENTIAL KNIFE cutting operations, select the TANG.
KNIFE option.
Keyboardcontrols 1-13
To Next Page
Loading...
