SummaSign series Cutters Service Manual
FLEX-CUT
FLEX-CUT can be set to OFF, to Mode 1 or Mode 2. When the cutter is set to mode 1
or mode 2, it will alternately cut one length with full pressure, and one length with
reduced pressure. The feature FLEX-CUT offers the advantage that it cuts completely
through the material, yet allowing the material to stay together by means of the small
media bridges.
MODE 1 is the quickest mode, but it is less precise because the pressure changes
during the cutting. MODE 2 is a lot slower, but at the same time it is much more
precise, as the cutter stops at every change of pressure. Pressing the
1 key will
activate the configuration menu, which allows you to set the cutting pressure and the
cut length.
1. CUT LENGTH
This parameter determines the length that is cut with full pressure. By pressing the
1
key, the FLEX-CUT test pattern will be cut.
2. FLEX-CUT LENGTH
This parameter determines the length that will be cut with reduced pressure or without
pressure. By pressing the
1 key, the FLEX-CUT pattern will be cut.
3. FLEX PRESSURE
This parameter determines the pressure of the FLEX-CUT LENGTH. By pressing the
1
key, the FLEX-CUT test pattern is cut.
RECUT OFFSET
The recut offset submenu is used to set or modify the distances between the drawings
when making multiple recuts.
The default recut offset value is 0 mm.
The distance can be set between o and 255 mm.
On the LCD, the active recut offset value is marked with an *.
1-18 Keyboardcontrols
To Next Page
Loading...