Summa SummaSign D1300 - Internal Test Menu

Service Manual SummaSign series Cutters
INTERNAL TEST MENU
 To access any internal test, proceed as follows:
1. Power the cutter on.
2. Load cutting or plotting media.
3. Install a knife or a pen.
4. Press the
key until INTERNAL TEST is displayed and press the jogging
key.
5. Press the
or jogging key until the desired internal test is displayed.
6. To perform the test, press the
key.
To exit from this menu and go to another menu, press the
key until the desired
menu is displayed.
To exit from the menus and put the cutter on line again, press the
key.
Keyboardcontrols 1-19