Summit SP - Page 19

Installation, Operation, and Maintenance Manual
SUMMIT PUMP MODEL SP 14
2.6
2.7
2.8
2.5
Fig 3.
16. Fit V-Ring Seal(2.7) into notch in Bearing Cover(2.5). (See Fig. 3)
17. Fit Labyrinth Assembly onto shaft sliding up snuggly to Bearing Cover(2.5)
18. Install Lock Nut(2.9) onto Shaft(2.1) tighten using spanner wrench.
19. Install Grease Nipple(2.11) into Bearing Cover(2.5) and Square Head Plugs(2.13)
into Bearing Housing (2.3)
20. Rotate Shaft(2.1) and pump grease into Bearing Cover(2.5) using Grease
Nipple(2.11) to fill Labyrinth assembly.