Sun Microsystems Sun Fire X4150 - Displaying Version Information; To Display the Current SP Version Information

Chapter 7 Using the Command-Line Interface 85
7. When you are finished, use the show command to verify the PEF configuration:
/SP/AgentInfo/PEF/EventFilterTable1–> show
The output from the command appears:
In the example above, EventFilterTable1 is enabled to activate the SendAlert and
SendMail actions, based on temperature related alerts.
Displaying Version Information
You can display active session, current versions, and other information about the SP
using the CLI.
To Display the Current SP Version Information
● To display the current SP version, enter the following command:
version
/SP/AgentInfo/PEF/EventFilterTable1
Targets:
Properties:
Status = enable
SensorType = temperature
PowerCtrl = disable
DiagnosticInterrupt = disable
SendAlert = enable
SendMail = enable
Target Commands:
show
set