Sun Microsystems Sun Fire X4150 - To Configure the PEF Global Controls; Configuring the Event Filter Tables

82 Sun Fire X4150 Server Embedded Lights Out Manager Administration Guide • September 2007
▼ To Configure the PEF Global Controls
1. To configure the PEF global controls, you must first enable global control by
entering the following commands:
–> cd /SP/AgentInfo/PEF
/SP/AgentInfo/PEF –> set PEFGlobalCtrl=enable
After enabling global control, you can enable global control for specific actions.
2. To enable global PEF control for a specific action, enter the following
commands for each PEFActionGlobalCtrl that you want to enable:
Note – This example shows how to enable the power reset PEF global action:
–> cd /SP/AgentInfo/PEF
/SP/AgentInfo/PEF –> set PEFActionGlobalCtrlPowerReset=enable
Configuring the Event Filter Tables
The event filter table is where you designate the specific altert-triggered actions. You
can configure up to six event filter tables. These targets, properties, and values are
valid for setting the PEF:
Target Property
/SP/AgentInfo/PEF/EventFilterTable[1-6]/status enable|disable
/SP/AgentInfo/PEF/EventFilterTable[1-6]/sensortype All, Memory, Processor,
Temperature, Voltage,
Fan
/SP/AgentInfo/PEF/EventFilterTable[1-6]/powercrtl enable|disable
/SP/AgentInfo/PEF/EventFilterTable[1-6]/diagnosticinterrupt enable|disable
/SP/AgentInfo/PEF/EventFilterTable[1-6]/sendalert enable|disable
/SP/AgentInfo/PEF/EventFilterTable[1-6]/sendmail enable|disable