Chapter 4 Configuring, Managing and Maintaining the Server Using the Web-Based Interface 31
■ Performing one of three power actions
■ Performing an NMI diagnostic interrupt
■ Sending alert to the SEL
■ Sending mail
An event is configured in two parts: the event (or alert) and the response or action to
be taken when that event occurs. You can configure up to six filters. You begin by
determining what sort of event you want to trap.
▼ To Configure a Platform Event Filter
1. From the Configuration submenu click Platform Event Filter tab.
The Platform Event Filter screen appears (see
FIGURE 4-2). The PEF screen is
divided into five sections:
■ Platform Event Filter
■ Trap Receiver Destination Address
■ PEF Action Global Control
■ Event Filter Configuration
■ Event Action Configuration
To Next Page
Loading...
