6 Sun Fire X4150 Server Embedded Lights Out Manager Administration Guide • September 2007
About Connection Tasks
You have two methods to connect to the ELOM in your server:
■ Serial/Local
■ Ethernet/Remote
Both methods require making physical cable connections to the server and logging
in to the ELOM; refer to
TABLE 2-1.
Note – The ELOM supports a maximum of 10 active sessions, including serial, SSH,
and web browser sessions.
Connecting Using a Serial Connection
You access the ELOM CLI by connecting a terminal or a PC running terminal
emulation software to the RJ-45 serial port on the server using the supplied cable.
▼ To Connect Using a Serial Connection
1. Verify that your terminal, laptop, or terminal server is operational.
2. Configure the terminal device or terminal emulation software to use the
following settings:
■ 8,N,1: eight data bits, no parity, one stop bit.
TABLE 2-1 Methods of Connecting to the ELOM
Connection
Method
Supported
Interface
Required
Cable Comments/Description
Serial, direct CLI only RJ-45
serial
(supplied)
Connect directly to the serial management port the on
server with a terminal or laptop running terminal
emulation software.
Ethernet CLI and
Web
browser
Ethernet
LAN
You must know the ELOM’s Ethernet address.
Note: This is the only method that supports web
browser access.
To Next Page
Loading...
