Suncast WRP7000 - Page 56

Meijer.com
Assembly/Second Floor (continued)
w
Sli de upper fl oo r (P6) down into p lace inside lett post
ry.l4) and middle post ry.l5).
Note: Make sure flat side of floor (side without poc kets)
is oriented in
center of play set where levels change.
On front lower section, loosely attach cross brace 0N 13)
to outs i de of middle post ry.t 2) and right pos t ry.t3) with
hex bolts (F12), l ock washers (F2), fl at washers (F3),
and T-nuts (F
4) In pre- dr illed holes. DO NOT ti ghten.
56
w
Sli de lowe r fl oor (P19) down in to place.
Note: Make
sure flat side of floor (side without cutouts}
is oriented in center of play set where levels change.
On ri
ght side, loose ly a tt ach cr oss brace ry.l13) to
outside
of righ t pos t ry.t3) and right post ry.t6) with he x
bolts (F 12), l ock washers (F2), flat washers (F3), and
T- nuts (F4) in pre-drilled ho les. DO NOT tigh ten.