CHAPTER
FOUR
PLAY WITH EZBLOCK
For beginners and novices, EzBlock is a software development platform offered by SunFounder for Raspberry Pi.
Ezbock offers two programming environments: a graphical environment and a Python environment.
It is available for almost all types of devices, including Mac, PC, and Android.
Here is a tutorial to help you complete EzBlock installation, download, and use.
4.1 Quick Guide on EzBlock
There are 2 parts here:
• Servo Adjust allows you to keep all the servos at 0 degrees to complete a proper and safe assembly (otherwise
you will probably damage the servos).
• Install and Configure EzBlock Studio will guide you to download EzBlock Studio to play with your robot.
4.1.1 Servo Adjust
When assembling to the part with the servo, you need to keep the servo at 0° and secure it with the servo screw. Please
follow the tutorial below to do this.
1. Firstly, Install EzBlock OS onto a Micro SD card, once the installation is complete, insert it into the Raspberry
Pi.
2. To ensure that the servo has been properly set to 0°, first insert the rocker arm into the servo shaft and then
gently rotate the rocker arm to a different angle.
85
To Next Page
Loading...
