SunFounder TS-10 10.1-inch Touch Screen
In the pop-up prompt box, choose to restart now.
After the restart is complete, use the following command line to check whether the camera is available.
If the camera screen appears it means that the camera is installed successfully. Otherwise the FFC cable needs to be
unplugged and plugged in again.
raspivid -o vid.h264
6.2 GPIO Extension Board
Before starting the project, you first need to know more about the pins of the Raspberry Pi, which is key to the build
circuit.
6.2. GPIO Extension Board 195
To Next Page
Loading...
