Sungrow COM100D - Installation Method; Wall-Mounting

5 Mechanical Installation User Manual
12
Type
Tool
Phillips
screwdriver
Rubber
mallet
Crimping tool
RJ45 crimping
tool
5.4 Installation Method
The COM100 can be installed in wall-mounting manner or pole-mounting
manner.
Be aware of the weight of the COM100 throughout the installation
process!
Tip over or fall of the device due to inappropriate operation can cause
personal injury!
5.4.1 Wall-Mounting
Mount the COM100 onto the concrete wall or metal surface
according to onsite conditions.
Avoid drilling holes in the utility pipes and/or cables attached to back
of the wall!
Operation personnel should wear goggles and dust mask throughout
the drilling process to avoid dust inhalation or contact with eyes..