13
A. Bed part
Loosen oil cap screw① to fill up the oil tank to the gauge
line③ of the oil gauge②. Afterwards, tighten the screw①
firmly.
B. Face plate
Dismantle the facet by unfastening two fixing screws of the
facet and add the sewing machine oil into an arrow
position. Reassemble the facet afterwards.
9) Lubrication check
[ Fig. 11 ]
[ Fig. 12 ]
①
②
③
“LOW”
“HIGH”
Caution
▶ Plug in only after oil supply is finished. If the operator mistakenly steps on the pedal with the
plug in, the machine will start automatically and can cause severe injuries.
▶ When handling lubricants, wear protective glasses or gloves to avoid contact with your eyes or
skin. Inflammation may be caused otherwise. Never drink lubricants since they can cause
vomiting or diarrhea. Keep it out of the reach of children
▶ Operate the machine only after adding oil when the machine is being used for the first time or
has been left unused for a long time.
To Next Page
Loading...
