16
12) Check for switch functions (thread trimming type)
[ Fig. 19 ]
: Conversion switch for presser foot lifting level
- When you press this switch, the light will come on.
The lifting amount of the presser foot will
automatically change to the maximum 7 mm
regardless of what the set-up data is in the top
cover dial. When you press the switch back, the
light will go off and the sewing machine will run at
the setting value as displayed in the top cover dial.
: Automatic back tack (B/T) selection switch
- This switch is designed to select Insert/Delete of
the start and end of B/T sewing.
: Switch for stopping needle bar at high position
- designed to raise the needle bar to the highest
position regardless of the stop position of the
sewing machine
: Conversion switch for the stitch length
- While this switch is on, the machine will run at
the setting value of the lower dial and when off,
the machine will operate at the setting value of
the upper dial.
①
②
③
④
① ② ③ ④
To Next Page
Loading...
