10
3) Installation of oil fan
※ Insert the projecting part of the oil fan ② into the
respective machine holes on the lower side of the table
①, and then push securely to the right. Fix the oil fan to
the four fixing spots ③ using 4 nails. (See Figure 3)
[Figure 3]
Nail
②
①
③
4) Adjustment of belt tension
Once the motor is installed, when the fixing nuts ①, ②are
fully unfastened on both sides, tension is created to the belt
④ due to the weight balance of the motor ③. At this
moment, fasten the fixing nut ① first, then fasten the fixing
nut ② tightly. (See Figure 4)
[Figure 4]
④
③
①
①
“K”
②
5) Installation of belt cover
⑴ Before attaching the belt cover “B”① to the machine
body, assemble in advance the rubber collar, fixing
washer and fixing screw on the to-be-attached side of the
cover as can be seen in picture “K”of Figure 5.
⑵ Lay down the machine on the back and then attach belt
cover “B”① onto the machine body. (See Figure 5)
[Figure 6]
⑶ Fasten belt cover “A”② to the machine body and the
top cover with the fixing screw③, as can be seen in
Figure 6. And make sure that the belt cover “A”② keeps
balance with the belt cover “B”① that was already
attached. (See Figure 6)
[Figure 5]
Fixing screw
Rubber collar
Fixing washer
③
③
③
①
②
To Next Page
Loading...
