34
6.19) Cleaning
6.19.1) Cleaning Cycle and Method
6.20) Handling of Waste Oil
When the waste oil can attached to the rear side of the table
is filled to the full, separate and empty the can.
Waste Oil Can
1) Make sure to turn “off” the machine power before conducting cleaning.
2) Assemble the parts which are disassembled for cleaning.
Caution
No. Cleaning Area Cleaning Frequency
1 Around hook Everyday
Thread take-up lever / Thread tension adjusting device Once a week
Around the moving and fixed blades.
Use air to clean the moving and fixed blades under the
needle plate.
Three times a week
2
3
1) When separating the waste oil can, take caution not to drop it to the floor.
2) Just in case for dropping the waste oil can to the floor, place cloth, paper or oil dish on the
floorwhen separating the waste oil can.
Caution
To Next Page
Loading...
Need help?
General
