SunStar SWF/C-UH1508-45 User Manual

7-57
■■
MACHINE SET: Sets frame limit
Select “2.MACHINE SET,”press and you will find the following screen: The function has three sub-menus.
① MACHINE SET
It sets parameters for machine set-up (selects CUT NEEDLE).
• CUT NEEDLE
This is for cutting sewing materials, not embroidery materials.
[NOTE] Needle designated for CUT NEEDLE does not support thread detection or trimming functions.
Ex) Designating needle #6 for CUT NEEDLE
Move the cursor to “2.CUT
NEEDLE”and press
CUTTING NEEDLE SET
1 => USE, 0 => NO
NO. 1 5 9
[100000000000]
When the cursor blinks at needle #1,
press “1”to designate CUT
NEEDLE. The cursor will then
automatically move to needle #2.
CUTTING NEEDLE SET
1 => USE, 0 => NO
NO. 1 5 9
[100000000000]
Move the cursor to needle #6 using
“0”
1. MACHINE SET
2. FRAME ORIGIN
3. FRAME LIMIT SET
CUTTING NEEDLE SET
1 => USE, 0 => NO
NO. 1 5 9
[100000000000]
With the cursor at needle #6, press
“1”to designate it for CUT NEEDLE

SunStar SWF/C-UH1508-45 Specifications

General

Brand	SunStar
Model	SWF/C-UH1508-45
Category	Sewing Machine
Language	English