SunStar SWF/C-UH1508-45 - Chapter 6 Basic Machine Operation

6-1
BASIC MACHINE OPERATION
CHAPTER 6
TURN ON THE MAIN POWER
YES
YES
NO
YES
YES
NO
NO
ARE THERE DESIGNS IN MEMORY?
READ IN DESIGN
SET-UP PARAMETERS
SET UP NEEDLE BAR
SET WORK POSITION
PUSH START
SET-UP FRAME OFFSET
DO YOU WANT REPETITION?
DO YOU WANT AUXILIARY WORK
(GAUGE, ETC.)
DO YOU WANT FRAME OFFSET?
READ IN DESIGN
READ IN THE SET-UP
IS THE OPERATIONG SYSTEM INSTALLED?
IS THE DESIGN
INPUT KEY PRESSED?
ARE THERE PREVIOUSLY WORKED DESIGNS?
(see 7.4.3)
YES
YES
NO
INSTALL OPERATING SYSTEM
AUXILIARY
READ DESIGN FROM
DISK OR TAPE
REPETITION