8-2
NO.
400 Encoder A signal does not vary
Error in A of the main shaft
encoder.
Check cable connection. Turn the
main power OFF and ON again.
401 Encoder Z signal does not vary
Error in Z of the main shaft
encoder.
Check cable connection. Turn the
main power OFF and ON again.
ERROR MESSAGE ERROR CORRECTION
NO.
600
Floppy drive not ready
No disk in the drive. Insert the disk in the drive.
601 Diskette sector not found
Disk is not formatted or is of a
different format.
Format or change the disk.
ERROR MESSAGE
ERROR
CORRECTION
602
Diskette drive A file not found No embroidery design in the disk.
Change the disk.
603
Write protect error Disk is write-protected.
Remove the protection tab.
604 Disk error Damaged disk.
Format or change the disk.
605
Diskette space insufficient No space in the disk for copying. Change the disk.
606
Drive open error
Disk was removed during
operation.
Insert the disk and re-work.
607
Floppy reading error Bad sectors in the disk. Format or change the disk.
608
Floppy writing error Bad sectors in the disk.
Format or change the disk.
609
610
611
612
613
Floppy driver error
Unknown disk error during
operation.
Format or change the disk.
Floppy driver error
Unknown disk error.
Try with a new disk.
ZSF, Barudan disk not available
Damaged disk. Try with a new disk.
Too many bad sectors
Damaged disk
(occurred during formatting)
Try with a new disk.
NO.
501
Repeat setting error
(X number* Y number
99)
Exceeded the set limit for
repetition work
Reset the limit so X*Y does not
exceed 99.
ERROR MESSAGE ERROR CORRECTION
8-4) ENCODER
8-5) REPETITION WORK
8-6) FLOPPY DRIVE AND COMMUNICATION
To Next Page
Loading...
Need help?
General
