7-15
■■
New Menu for Design Calls
⇒ Revision of the functions in “7.4.1) In and Out of Design”
Select a design using EMB CALL or FDD CALL and you will see the following screen.
Place the cursor at “1. BASIC SETTING”and press to do basic set-up.
Basic set-up procedure is the same as pressing in the start menu.
Press to end the set-up.
Place the cursor at “2. NEEDLE SETTING”and press to set-up the needle bar.
Needle set-up procedure is the same as pressing from the start menu.
Press to end the set-up.
At [Screen 1], you can press to start embroidery work or select “3. EMB CALL”to re-select design.
[ Screen 1 ]
1. BASIC SETTING
2. NEEDLE SETTING
3. EMB CALL
1] X_SCALE : 100[%]
2] Y_SCALE : 100[%]
3] ANGLE : 0
4] MIRROR : NO MIRROR
==== NEEDLE SELECT ====
[1 ]: 1 / 1
[END] [INSERT] [DEL]
1. BASIC SETTING: menu for basic set-up
2. NEEDLE SETTING: menu for needle bar set-up
3. EMB CALL: menu for design selection
[Screen 2]
[Screen 3]
To Next Page
Loading...
Need help?
General
