8 • Questions? Call or Text +1-801-658-0015
Zapp
™
User Manual
• See Figure 7.3. Sharpening the electrode in a
quality of the weld.
• Set the electrode on the diamond disk at a
15-degree angle and begin to spin the elec-
Tip:
A helpful way to get a sharp electrode is to
push down on the electrode with your index
•
the rotary tool and insert the electrode back
into the stylus as explained above.
Shield Gas Setup
During the pulse arc welding process high temperature
plasma quickly melts metal into a molten pool. As the
weld is performed, a small amount of shielding gas is
released through the weld stylus to prevent oxygen
from entering the molten pool. After the weld has oc-
If oxygen from the air enters this molten pool, the result
is a metal oxide that is brittle, porous, and burnt-looking.
Protective shielding gas is used, such as 99.996% pure
PRESSURIZED GAS SAFETY
There are several important rules that should be fol-
lowed when using a compressed shielding gas such as
argon:
Need argon gas? Sunstone will
ship a right-sized tank to your
doorstep. No more adventurous
trips to the gas store! Call
Sunstone for immediate
delivery: +1 801-658-0015 or
scan the QR code above.
For Pop-Ups and other
remot locations, try the new
Argon Mini! Call Sunstone for
immediate delivery: +1 801-
658-0015 or scan the QR code
above.
Purchase premium argon gas from Sunstone.
Call +1 801-658-0015
visit www.sunstonewelders.com/gas.
• Delivered directly to your door!
•
• Premium argon gas for your Zapp Plus!
To Next Page
Loading...
