SunTech ST940 - Page 49

Doc. Title
ST940 User Manual
Concerning:
Rev.
Date (dd-mm-yy)
Page of Pages
Features and how to configure ST940
1.19
0
19-06-15
15
49 of 51
 Step 2.
Disconnect internet if internet was already connected to the PC.
 Step 3.
Please connect the ST940 with PC by using the USB cable.
 Step 4.
If “Device Manager” of your PCdisplays the 2 ports such as “MTK USB Debug Port (COMX)” and “MTK USB
Debug Port (COMY)” as shown in the picture below, it means that you have made a successful installation.
 Step 5
Please connect internet to the PC.
 Step 6
Please remove the USB cable from the PC and connect it with the PC to check if the PC displays “MTK USB”
successfully. If yes, it means that you have made a successful installation.