12
Maintenance of the Stoneware Pot
1. The stoneware pot will not withstand the shock of sudden temperature changes.
2. The stoneware pot should be at room temperature before adding hot foods.
3. Do not preheat slow cooker before using unless specified in the recipe.
4. If the stoneware pot has been preheated or is hot to the touch, do not put in cold
foods.
5. To wash your stoneware pot right after cooking, use HOT WATER.
Special Safeguards for Glass Lid
CAUTION: Failure to follow these instructions may cause immediate or later breakage
of glass lid, which can result in personal injury or property damage. Carefully read and
follow the safeguards below.
CAUTION: Glass lid can shatter from direct hea
t.
1. Do not place lid under broiler, microwave browning element or in a toaster oven.
2. Do not set lid cover on hot burner or oven heat vent.
3. Do not use lid if it has been used in the above manner even if it does not look
damaged. See the replacement parts section in this booklet on how to obtain a
replacement lid.
CAUTION: Glass lid can shatter if cooled suddenly. Avoid severe temperature change.
4.
Do not set hot glass on cold or wet surface; let cover cool before placing in water.
5.
Always handle hot lid with dry pot holders or oven mitts; do not use wet cloths.
6.
Always set hot glass lid on dry, heat-protective surfaces for gradual cooling.
CAUTION: Chips, cracks, or deep scratches weaken the glass lid. Weakened glass can
shatter during use.
13
7. Do not use lid if chipped, cracked or scratched. Discard immediately. See
replacement parts section in this booklet on how to obtain a replacement lid.
8. Always follow use and care instructions in this booklet to avoid chips, cracks and
scratches due to hitting rims, using metal utensils, using abrasive scouring pads or
cleansers, or from accidental impact.
User Maintenance Instructions
This appliance requires little maintenance. It contains no user serviceable parts. Do not
try to repair it yourself. Refer it to qualified personnel if servicing is needed. Always
unplug the unit and allow it to cool before cleaning.
To Next Page
Loading...