SUNWARD SWE20F 2019 - 4.2.3 Gear Oil

59
7) Take off the outlet plug, pour the oil into a 10L container through a clean cloth.
8) After oil is vented, check whether there is metallic chipping on cloth.
9) Fit and screw down outlet plug.
10) Clean surrounding area of engine oil filter seat. Turn the filter cartridge anti-clockwise to
remove old seals.
11) Clean sealed washer surface of filter seat.
12) Wipe clean oil on the seals of new filter.
13) Fit new filter, turn filter clockwise until the washer touch interface. Ensure not to damage
washer when fitting filter.
14) Screw down engine oil filter. Remember not to make it too tight to prevent screw thread
distortion or filter core seals damaging.
15) Open oil filter cover, and fill recommended oil in engine 15 minutes later, check whether the
oil level lies within the marking range or not.
16) Fit filler cap.
17) Start engine. Run at low revs for 5 minutes.
18) Check whether the engine oil pressure indicator light goes out at once, if not, stop engine
and check for the reason.
19) Stop engine, take out key from key switch.
20) Check whether there is any leakage at outlet plug.
21) Check oil level on dipstick
4.2.3 GEAR OIL
Parts name Qty
Interval (hours)
8 50 100 250 500 1000 2000
1、Slewing reducer
Check oil
level
— △
Replace
2L
△
2、Traveling reducer
Check oil
level
— △
Replace 2x2 L △
The engine oil may be very hot,
please be cautious of scalding.