Supermicro C7Z87 - Page 87

Chapter 4: AMI BIOS
4-19
cards palette and mimic it for proper color display. The options are Disabled and
Enabled.
PERR# Generation
Select Enabled to allow a PCI device to generate a PERR number for a PCI Bus
Signal Error Event. The options are Enabled and Disabled.
SERR# Generation
Select Enabled to allow a PCI device to generate an SERR number for a PCI Bus
Signal Error Event. The options are Enabled and Disabled.
Slot1 PCI 33 MHz OPROM/Slot2 PCI 33 MHz/Slot3 PCI-E 2.0 X1 OPROM/
Slot4 PCI-E 3.0 x8 (In x 16) OPROM/Slot5 PCI-E 2.0 x1 OPROM/Slot6 PCI-E
3.0 x16 OPROM/Slot7 PCI-E 2.0 x1 OPROM
Use this feature to enable or disable Option ROM support to boot the computer us-
ing the device installed on a PCI or a PCI-E slot specied by the user. The options
are Disabled, Legacy and EFI.
Launch Storage OPROM Policy
This feature controls how the system executes UEFI (Unied Extensible Firmware
Interface), and legacy storage OPROM. Select Legacy Only to boot the system using
a legacy device installed in a PCI slot. The options are UEFI Only and Legacy Only.
Other PCI Device ROM Priority
This feature selects a PCI device Option ROM for system boot if this device is not
a network, mass storage, or video device. The options are UEFI Only and Legacy
Only.
Onboard LAN1 Option ROM/Onboard LAN2 Option ROM
Select iSCSI to use the iSCSI Option ROM to boot the computer using an iSCSI
device installed in a LAN port specied. Select PXE (Preboot Execution Environ-
ment) to boot the computer using a PXE device installed in a LAN port specied.
Select Disabled to prevent system boot using a device installed in a LAN port.
The options for Onboard LAN1 Option ROM/Onboard LAN2 Option ROM are Dis-
abled and PXE.
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unied
Extensible Firmware Interface) for network stack support. The options are Enabled
and Disabled.