Supermicro C7Z87 - Page 97

Chapter 4: AMI BIOS
4-29
CPU on-die temperature increases, the fan speed will also increase for effective
system cooling. Select "Full Speed" to allow the onboard fans to run at full speed
(of 100% Pulse Width Modulation Duty Cycle) for maximum cooling. This setting
is recommended for special system conguration or debugging. Select "Standard"
for the onboard fans to run at 50% of the Initial PWM Cycle in order to balance the
needs between system cooling and power saving. This setting is recommended for
regular systems with normal hardware congurations. The options are Full Speed
(@100% of PWM Cycle), and Standard (@50% of PWM Cycle).
The following items will be displayed:
•CPU Temperature (PECI)
•Front Side Sys. (System) Temperature
•Rear Side Sys. (System) Temperature
•PCH Temperature
•Fan 1 Speed ~ Fan 5 Speed
•VCORE
•12V
•VDIMM
•5Vcc
•PCH 1.05V
•AVCC
• 3.3Vcc
•VSB
•VBAT