SC825 Chassis Manual
5-6
3. Install a new drive into the carrier with the printed circuit board side facing
down so that the mounting holes align with those in the carrier.
4. Secure the hard drive by tightening all six screws.
5. Replace the drive carrier into the chassis bay, making sure that the drive car-
rier handle is completely closed.
Drive Carrier
SAS/SATA
Hard Drive
Figure 5-5. Removing the Hard Drive
Figure 5-6. Installing the Hard Drive
1
4
1
4
1
5
Note: Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers.
To Next Page
Loading...
