Supermicro SSE-G24-TG4 - Saving Configurations

Release: 1.0a 16 / 24
Supermicro Switch Web GUI Quick Configuration Guide
 Enable Link Status Tracking – Choose Enable and click on the Apply button on the left
panel.
 Configure the Group ID as 1
 Configure the Upstream Interfaces as gi0/15
 Configure the Downstream Interfaces as gi0/1-14
 Click on the Add Group button.
Note:
If more than one uplink port is configured, all downstream ports will be brought down only when
all upstream ports are down.
2.9 Saving Configurations
Switch configurations can be saved on the System Mgmt  File Management page.
You can save a currently running switch configuration in one of three ways.
• Save Startup Config – This option saves the current running configuration in local flash
with the file name configured as “startup configuration” file. This configuration will be
loaded automatically every time the switch reboots.
• Save Flash File – This option saves the current running configuration in local flash with a
user-specified file name.
• Save Remotely – This option saves the current running configuration in a remote TFTP
server. For this option you will need to provide the IP address and file name of the TFTP
server.