Supermicro SSE-X24S - Page 13

Supermicro L2/L3 Switches Configuration Guide
13
Step 2
authorized
-
manager ip
-
source <ip
-
address>[{<subnet-mask> | / <prefix-length(1
-32)>}] [interface [<interface-type <0/a-b, 0/c, ...>]
[<interface-type <0/a-b,
0/c, ...>]] [vlan<a,b or a-b or a,b,c-d>] [service
[snmp] [telnet] [http] [http
s] [ssh]]
Configure
s
the authorized manager
ip-address – Manager IP address
subnet mask – For a given Authorized
Manager entry, the switch applies the
subnet mask to the IP address to
determine a range of authorized IP
addresses for management access
prefix-length- Prefix length of the IP
address, from 1-32.
interface-type – Specifies the interface
type through which the IP authorized
manager can access the switch. May be
any of the following:
gigabit ethernet – gi
extreme-ethernet – ex
qx-ethernet – qx
vlan
interface-id is in slot/port format for all
physical interfaces. It may be the VLAN
identifier for VLAN interfaces.
vlan -Specifies the vlan id through
which the IP authorized manager can
access the switch.
service – Specifies the services that can
be accessed by the authorized manager
Step 3
end
Exits the configuration mode.
Step 4
show authorized
-
managers
Displays the Authorized Managers
configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
If IP Authorized Managers are configured in
a
Supermicro switch, access to switch via telnet,
ssh, etc. is possible only by those hosts given access. Other hosts will not be permitted
access to the switch.
The “no authorized-manager ip-source <ip-address> [{<subnet-mask> | / <prefix-length(1-
32)>}]” command deletes a particular authorized manager.